Hi everyone! I have a Ford Focus MK3, 2.0 Duratec engine, 49k miles, for which I wanted to change the whole coolant/water mix for maintenance purposes.
The manual says the whole capacity is 6.5L, 50% should be concentrated coolant and 50% distilled water.
So I bought 4L of Total coolant (organic, red color); 3L to use for sure and 1L just in case it needs a bit more, aiming to save what’s left.
I brought the 4L to a mechanic who did the whole job. Sadly I wasn’t clear enough and just trusted that he would know but… he actually put all of the 4L of coolant and completed it with distilled water.
So now I guess the car has a mix with approximately 65/35 coolant/water which is not what the manual suggests, but the mechanic told me it is “better” that way.
What do you suggest?
- Do I move on and just keep an eye on the temperature indicator? (I read that coolant’s heat transfer capacity is not as good as water’s).
- Do I, somehow, “adjust” the mix by getting some out of the deposit and filling with water? I don’t know how to “get some out”, but I read some people use turkey basters for removing excess.
- Do I replace everything again? The bad part is all of the cash I spent on the 4L of coolant and the mechanic’s work.
Thank you in advance!
While not ideal, it’s likely just fine. If you leave it in, just keep an eye on temperatures. Other than possibly being a bit warmer (though unlikely), there are no other concerns here.
Why would coolant be a bit warmer? Are you aware that antifreeze suggests “non-freezing?” I’m sure you have heard that people can put water in radiator. People can pee in radiator. Doesn’t matter what’s inside for the liquid to transfer engine heat to radiator. Any liquid can basically work to take engine combustion temps and transfer it to radiator to cool off
The problem with piss and water in radiator is the freezing point. When you park your car, water will freeze at 32 degrees. Good thing there is antifreeze which has a way lower freezing point. That’s the main purpose of glycol. To not freeze
You seem to be asking questions while already having your mind made up. Were those rhetorical?
Pure water dissipates heat better than coolants. So it would be logical to say that pure water could keep an engine cooler. Pure coolant would keep an engine a bit hotter. Keeping with this logic, having a 60/40 mix of coolant/water would keep an engine just a bit warmer than a 50/50 mix.
The main two issues with running pure water are freezing point (as you mentioned), and the corrosion protection additives in coolant. If we didn’t have to worry about either of those issues, people would be better off running pure water all the time.
In OPs case, they likely have enough anti-freeze properties in their coolant. It likely won’t over heat. And they likely have enough concentration of anti-corrosion additives as well.
Boiling point doesn’t matter. That’s what the radiator pressure is for. To raise boiling points. Your car operates at 190. Straight water boils at 212. High speed fans kick on at 210-225. Adding pressure to a pressurized system will effectively raise any boiling point of liquids. Your car won’t run hotter or colder. That’s controlled by thermostat.
Antifreeze/coolants MAIN benefit is to prevent freezing when car is off and parked in cold climates.