I have used one like this before. There are others out there as well but the concept should be the same. It would help ensure you are level across both of your lead screws.
https://www.printables.com/model/7467-tool-to-level-x-axis-of-prusa-i3-8mm-rods
Have you put the printer through the xyz axis calibration as part of your troubleshooting?
https://help.prusa3d.com/article/xyz-calibration-mk3-mk3s-mk3s_112351
Do you happen to have a video example? It sounds like there might be a few different issues going on at once.
Does it seem to hit the printbed in the same area? It could be that the bed itself isn’t fully level. I’ve seen some prusas have the frame itself warped. It might be worth looking into the nylock mod. That combined with the octoprint plugin for prusas leveling should help getting your bed perfectly flat and rule out any issues there.
You mentioned updating firmware and sd cards but what is the slicer you are using? I doubt that would cause any of the issues you are seeing but worth checking off the box.
The oozing could be due to the hot end being set too high for your filament or potentially it may be too saturated and needing to be dried. How old is the filament you are printing with/how are you storing it? What material/temps are you running?
There could be something up with your stepper motors and/or wiring. If you move the bed/extruder around through the settings menu can you replicate any of the odd behavior?
Another thing to check is if your z axis is fully level? There are some small tools for getting a consistent height on both lead screws. I’m curious if one of the steppers is going bad and leading to things getting misaligned and other knock on effects.
Thanks for asking for help vs just giving up. When I first got mine I had a hell of a time with clogged ptfe tubes in the hotend/extruder. I had to disassemble my printer like 30 or so times to ultimately figure out it was because I had the headers flipped for the heat sink fan and the part fan leading to bad heat creep and maybe a hundred or so hours of pain.
Edit: on mobile, I’ll try to swing back tomorrow and drop some links for the various mods/tools
Thank you for the transparency! It is important to remember that it’s not just the amazing work the mods do here but there is a real cost to running this.
Not quite the same puzzley aspect but check out etrian Odyssey. It’s premise essentially is that you have a dungeon crawler and you have to make the map yourself. There are tools in game for making the map as you go.
Especially when those peaky entertainment studios are cutting trees down to keep shade off picket lines.
I got to see them open up for timecop 1983 a few years back. Effectively unknown they instantaneously won everyone at the show over with “Heaven’s servant”. Thanks for sharing this! I missed that they had some new music.
Heck yeah! Thanks for getting this up
Something like status-page is always nice. I haven’t used it but it looks like https://cachethq.io/ could be a decent fit as well.
I’m loving all of the TUIs cropping up lately. Thanks for sharing!
https://help.prusa3d.com/article/ambient-temperature-check-mk3-mk3s_161230 if that triggered something sounds quite wrong. Might be worth going back through support again