2016 Jeep Renegade sport
I recently ordered a Mopar clutch kit for my Jeep with the friction plate and pressure plate. They machined the flywheel and I paid around $1200 for labor. A few days after the repair was completed, the clutch pedal dropped to the floor.
Do clutch kits typically come with slave cylinders? The kits I have seen online don’t seem to, and it wasn’t mentioned to me at all as a need during the original repair. They said they need to take it apart and check the cylinder now and let me know, so I’m a little worried the labor is going to hit 1200 again.
Any info/advice regarding this situation? Just looking to be informed when we have our follow-up conversation.
If its a concentric slave cylinder inside the gearbox i would personally never replace a clutch without replacing it as precaution.
Most suppliers over here can offer a 2 or 3 piece clutch kit depending on make/model. I refuse to even quote on doing the job without doing the lot at once for the exact reason you’re facing. Worn concentric slave cylinders fighting against new clutch pressure plates often leads to tears.
Side note; how much did they machine the flywheel? Is it possible they’ve removed too much material and the slave has over extended?
You are saying something important in a subtle fashion. I’ve heard mechanics say there it’s a difference when the customer brings in a part and says replace it instead of asking to solve the problem.
When asked to solve a slipping clutch the mechanic recommends the best solution that they can warranty. So they recommend replacing the clutch plus any difficult to replace wear items they would touch while in there.
When you bring a part and ask for them to replace it you provide the warranty. So the mechanic replaced the clutch and calls it fine.
I like to be knowledgeable too. But if I find someone I trust to do a job I let them call the shots.
Just to clarify, they were having trouble sourcing the clutch kit from their regular sources, so I found the Mopar kit online and ordered it in to expedite things a bit, I wasn’t diagnosing and suggesting any fix.
No, clutch kits usually don’t come with a new slave. And yes it’s more than likely your slave has gone bad if the pedal has lost pressure. Good thing is that slaves are cheap, bad thing is yours is most likely internal so they’ll have to pull the transmission out again to replace it.
Well a couple days… after… I would check the fluid see if there is any… they need further bled… improper installation, damaged fiittings or o rings during the repair.
Depends on the kit, but generally no. This slave cylinder is internal, as in mounted on the transmission input shaft, so they would have to remove the transmission again.
But I would first insist they try and bleed the system of air
Sounds legit assuming the slave cylinder was not showing signs of an issue during the clutch install. Not typically replaced with a clutch at least in cars I’ve owned.
I’ve had one fail on me with the same symptoms as yours, usually a cheap fix…