Title says it all. Shelly devices are only rated up to 105F, and I need to control an outlet in my attic (it powers a hot water recirculation pump). It needs to work with an inductive load since it’s powering a motor.
Any suggestions? It can be Z-Wave, Zigbee, or WiFi. Will tie back to Home Assistant.
It’s a pump physically attached to a water heater that I’m controlling. The outlet and pump are both in the attic and that space gets up to 120° or more during the summer.
Clearly I misread the original post. A remote relay would be the simplest solution, assuming there are no outlets down-wire from the one you’re looking to control. Otherwise you’re likely looking at an extension cord to another outlet or doing some home wiring.
I’m not a plumbing expert and don’t know your pump brand, but most recirculating pumps I’ve seen are at, or near, the lowest part of the household piping, to reduce wear from pumping air, and to be accessible for maintenance. I would not want an electronic motorized machine that pumps water above the ceiling being roasted all summer.
No doubt it was a hassle for you to install the pump and outlet in the attic, but are you sure this was the best long-term solution?