RealisticBroccoli

New fear unlocked. thank you

whichever contains the most amount of butter…

i don’t get it either why people still use them.

BME280 or a sht40 which gives a more accurate humidity readings.

can’t wait to try it out. could you post the link to this post please?

I added an aerogel foam fromnaliexpress to my bed. So not sure how much aerogel is embeded in there. Could be it is just some glasfiber foam or something like that.

Temperature under the bed droped by at least 20C while printing Pla. Heating time droped slightly but my bed is pretty fast anyway. I couldn’t measure a noticeable drop in power consumption. But I measured it just like 15min each run.

This sheet was 15-20€ for 50x50x1cm

So I think the temp drop alone is worth it at least for me. And there should be a power consumption drop for longer prints.

yeah session management finally. thank you to all KDE devs

we have a prusa mini for several years at work. i am printing quite a lot and had zero issues so far. if you buy the mini: order the wifi module.

von der Reiche letztes Jahr… warum wurde das im Artikel nicht erwähnt?

is it Abs? if so you could try welding it with acetone.

wero could replace PayPal if they don’t mess up… shops just need to adopt it next year.

Nürnberger! Zwei passen perfekt.

solid edge has a free community edition. completly offline.