Take pictures before you remove the pins.
Take pictures before you remove the pins.
Fliud Film has stopped the progression of rust on my vehicle for seven years. https://www.fluid-film.com/automotive-applications/
Have it sprayed by Fluid Film if you live in a salt state.
Which is closer? A battery supplier or the gas station?
If the reflective coating is flaking, you’ll need to replace the unit.
Search “The Club” for a steering wheel lock.
Run a bottle of Redline thru the tank first. It has the highest amount of cleaning agents. https://www.redlineoil.com/Content/files/tech/SI-1_Tech_6.20_.pdf
Expect about 7mpg. Check the trans level when hot. Black with a burnt smell is not good. 150k is about the limit on a non-maintained tranny.
Buy a cheap pencil style and compare. They’re accurate. Take the gauge into the house and warm it up. Then smack it and see if it resets.
You need to take a trip to recondition the oil. Water, fuel and contaminates build up from short trips. 30 minutes to an hour of highway driving burns them off. The PCV and emissions system get dirty on short trips and that can affect mileage.
Yes. Any bleed off reduces the energy to jump the spark gap. I’ll bet that plug is dirty.
Straight sixes have been around for over 100 years. They’re reliable and simple to work on. Pour some oil in the cylinders and let it set a while before you turn the engine over by hand.
Lower as much as possible or let some air out. Jack up the rim far enough to tilt the holding arm into the hole.
Redline works in one tank: https://ricksfreeautorepairadvice.com/fuel-injector-cleaner/
This is what it does: https://www.redlineoil.com/Content/files/tech/SI-1_Tech_6.20_.pdf
The BCM on my '08 is above the spare tire and requires a ground to the hoisting mechanism. It will show unrelated codes if the ground is bad. Check the fuel pump relay. There may be corrosion on the underside of the fuse block.
When it comes to tight spaces, I grind down a flat edge screwdriver to a chisel point. Lap the backside to remove burrs and push gently at an angle.
You’ll have to join to download but this may help: https://mhhauto.com/Thread-2011-2013-2016-Dodge-Grand-Caravan-3-6-wiring-diagrams
Use adhesive lined heat shrink butt conectors for a permanent fix. Soldering is no longer recommended.
It damaged your wallet. Gumout HM has 1% of PEA, the cleaning agent. Redline has up to 50%.