Mates bread maker stopped working so I had a look inside and saw this burned resistor.

I’m guessing the heat changed the colors a bit so wondering if anyone has experience in reading cooked resistor values.

I removed it from the PCB and measured it at 403 Ohms.

Thanks for any help.

  • WaltzingKea@lemmy.nzOPEnglish
    1·
    1 year ago

    The case is basically fully metal, just a bit of plastic inside for mounting the PCB to and a few other bits of plastic outside. Plus there is a temperature fuse in the case also.

    From the resistor size (11.5 x 4.5mm) I think it would have been a 2W resistor when comparing to sizes on Digikey. I made a 500 Ohm 2W resistor from 8 1/4W 1K resistors then put a larger resistor in parallel to that to bring it down, measured it to 489 Ohms.

    I’m going to run it a few times then open it up again to see if there is any new damage to the board before returning it.