I was trying to replace a stud for my 09 Altima 2.5. didn’t find any space or gap to get the stud out. Tried to spin whatever the position it can be but no luck. Any advice? Anyway that can take that thing off cost effectively?

  • Shamino79@alien.topBEnglish
    1·
    10 months ago

    My bad, I was half asleep. I had presumed he was going to mutilate the stud. He’s talking about gouging a hole in the side of the assembly behind. Have to take a fair chunk out to make it happen. Couldn’t be that difficult to get a pin out and start undoing a nut.

    • ZSG13@alien.topBEnglish
      1·
      10 months ago

      Grinding the head of the stud would be enough I bet. Super quick and easy. Removing a cotter pin and a nut will leav OP very far from being able to complete the job

        • ZSG13@alien.topBEnglish
          1·
          10 months ago

          OP posted that the replacement stud has a notch cut out in order to fit in. What else is in the way, the small bit of backing plate that hasn’t rusted away yet? Cut or bend it. I doubt the knuckle would be in the way