Hi everyone i am at my witts end. Ive tried chisel/hammer, prybar, and tapping hammer on the end of prybar. After hours of doing that, it pulled out maybe 1mm lol. I used a slide hammer and it ripped the axle off, leaving the cv halfshaft. i went and got an attachment to attach to a vise grip but it keeps slipping off eventually. Ive been at this for almost 3 days now i’m not sure what else i can do at this point. Any advice is appreciated. Thanks!!!
Good job. I have never failed to get one out, although I have had tough times. I have found that using one pry bar will cause it to tilt to one side making it bind more. Using two pry bars, one on each side, and trying to apply force as perpendicular as possible usually does the trick. A lot of the time with this method I don’t even need a long pry bar, I can use two big screwdrivers and just give them a little wiggle